Flavor Burst TS 44SS/BEV, Instruction Manual

Page: 71 / 112

70
Mounting the Tube / Cable Casing
Assemblies
The TS 44SS/BEV includes three stainless
steel casing assemblies. Two of them house
and hold the 9-Tube Assembly level with each
Injector / Blending Assembly. The other Casing
is for channeling the Touchscreen power cord
to the back of the unit and out of the way.
The following instructions and illustrations show
a left-side mounting, which is typically the side
with the intake vents on the Taylor C708 model.
However, your freezer may have the intake
vents on the right side; in those cases, install
the Casing on the right side. It is
recommended to install the Casing holding the
9-Tube Assembly on the
intake vent side to
prevent heating the syrup tubes.
1. The Casing Assembly contains very power
magnets to attach to the side of the freezer.
Simply place the assembly in line with the
Injector / Blending Assembly with the hinged
surface down (holding screw at the top).
The curved ends of the Casing should hang
over the front and back of the freezer and
the assembly should be level horizontally.
2. Remove the screw from the top of the
Casing Assembly.
3. Swing the Casing cover outward.
4. Carefully place the 9-Tube Assembly inside
the Casing. Pull any excess tubes and
cables to the back of the freezer, allowing
enough slack in the front to comfortably
curve around to the Injector / Blending
Assembly.
5. Close the casing, taking care not to pinch
any of the lines.
6. Install the screw to secure the Casing.