52
Cleaning the Spout Adapter
The Spout Adapter does not require daily
cleaning under normal operating conditions.
Since the fitting is very tight, install the Adapter
with the freezer door removed. Therefore,
clean only as needed or when disassembling
the freezer door for cleaning (approximately
every 2 weeks). Replacement o-rings are
available in the Spare Parts Kit.
NOTE:
THE ADPT 8750-A ADAPTER (SOFT
SERVE) and ADPT 104R-A (FROZEN
BEVERAGE) DO NOT INCLUDE A GASKET.
IF EITHER OF THESE ADAPTERS ARE
INSTALLED, IGNORE REFERENCES TO THE
GASKET WHEN CLEANING THIS ADAPTER.
1. Mix approved detergent with warm water
according to manufacturer’s instructions.
Also, prepare approved sanitizer solution
according to manufacturer’s instructions.
2. Remove the Spout Adapter from the freezer
spout. Since the fitting is very tight, you may
need to use a small tool to pry the Adapter
from the door spout.
3. Remove the two black o-rings and white
gasket from the Spout Adapter.
4. Clean the two o-rings, the white gasket and
the Spout Adapter with a small brush and
detergent water, and rinse thoroughly.
5. Place the Spout Adapter, o-rings, and white
gasket in approved sanitizer solution and
soak for at least 1 minute.
6. Remove each part from the sanitizer
solution and place them on a sanitary tray to
air dry.
Summary of Contents for TS 44SS/BEV
