Flavor Burst TS 44SS/BEV, Instruction Manual

Page: 61 / 112

60
NOTE:
PROCEDURES AND INSTRUCTIONS
MAY APPLY TO FROZEN BEVERAGE
PARTS, FREEZERS AND FITMENTS EVEN
WHEN ILLUSTRATIONS SHOW ONLY SOFT
SERVE PARTS, FREEZERS AND FITMENTS.
Installing the Spout Adapter
The TS 80SS/BEV system attaches to the
freezer spouts with a Spout Adapter. Each unit
ships with two soft serve Spout Adapters (
ADPT 101A standard Adapter common to most
freezers and ADPT 8750A alternate Adapter for
use with most Taylor Crown Series freezers)
and a frozen beverage Spout Adapter (ADPT
104R-A). However, if these Adapters do not fit
your freezer spouts, additional Adapters are
available from your local distributor for use with
other models and freezer manufacturers. See
the ALTERNATE PARTS AND KITS BY
FREEZER MODEL section for more
information.
Since the fitting is very tight, install the Adapter
with the freezer door removed. Keep
replacement o-rings and gasket in the Spare
Parts Kit.
NOTE:
THE ADPT 8750A ADAPTER (SOFT
SERVE) and ADPT 104R-A (FROZEN
BEVERAGE) DO NOT INCLUDE A GASKET.
IGNORE REFERENCES TO THE GASKET IF
THIS ADAPTER IS INSTALLED.
1. Ensure that the Spout Adapter has been
sanitized according to instructions in the
SCHEDULED MAINTENANCE section.
Then lube and install the white gasket and
both o-rings in their proper places inside
and outside of the Spout Adapter.
2. Clean the freezer door and spout according
to manufacturer’s instructions before
installing the Spout Adapter on the freezer
door.
3. Set the Adapter on a flat, clean surface, and
then place the freezer door spout upright
onto the Adapter. Rock the freezer door
forward to snap the Adapter into place.
4. Return the door to the freezer with the
Spout Adapter attached.
5. Repeat Steps 1-4 to install the Spout
Adapter on the other freezer.
EQUIPMENT SETUP