Flavor Burst TS 44SS/BEV, Instruction Manual

Page: 66 / 112

65
Installing the ELE 510 Spigot Switch
Internally on a Taylor 428 / 432 Freezer.
Flavor Burst highly recommends integrated
switches be installed to power the TS
44SS/BEV system.
However, if no integrated
switches are available at the time of installation,
use the ELE 510 external switch included with
this system. The ELE 510 can also be mounted
inside the front panel of Taylor 428 and 432
models as directed below.
NOTE: ENSURE THE FREEZER IS TURNED
OFF AN UNPLUGGED TO AVOID ANY
ELECTRICAL SHOCK WHEN WORKING
WITHIN THE TAYLOR 428 / 432 PANEL BOX.
1. Unscrew and remove the front panel from
the Taylor 428 or 432 freezer.
2. Attach one small square pieces of adhesive
to front bottom of the flat bracket piece that
comes with the ELE 510 switch. Attach
another piece of adhesive to the upper end
of the bracket on the other side. Then,
attach the switch behind that upper
adhesive piece as shown, with the switch
lever pointing to the right.
3. Attach the switch assembly just left of the
Taylor internal switch, to the inside of the
cover plate. The ELE 510 switch lever
should be just above the internal draw pin
as shown.
4. With the freezer turned off and with no
product in the freezer, pull the handle into
the open position to see if the draw pin
depresses the switch lever. If not, reposition
the switch so that it makes full contact.
NOTE: THE SWITCH MUST BE POSITIONED
SO THAT THE SWITCH LEVER IS FULLY
DEPRESSED WHEN THE DRAW HANDLE IS
IN THE OPEN POSITION.
5. Slide the switch cable jack through the
center slot at the back of the panel.