Flavor Burst TS 44SS/BEV, Instruction Manual

Page: 54 / 112

53
7. Lube the black o-rings and install them with
the white gasket in their respective positions
on the Spout Adapter.
8. Clean the freezer door and spout according
to manufacturer’s instructions before
installing the Spout Adapter on the freezer
door.
9. Set the Adapter on a flat, clean surface, and
then place the freezer door spout upright
onto the Adapter. Rock the freezer door
forward to snap the Adapter into place.
10. Return the freezer door to the freezer with
the Spout Adapter attached.
Replacing Injector / Blending Head O-Rings
The Injector / Blending Head o-rings are wear
items and will need to be replaced periodically.
Always keep spares of these items on hand in
the Spare Parts Kit for replacement.
1. Mix approved detergent with warm water
according to manufacturer’s instructions.
Also prepare approved sanitizer solution
according to manufacturer’s instructions.
2. Remove the worn o-rings from the Injector /
Blending Head. A small tool may be
needed to remove the two o-rings in the
syrup line opening.
3. Brush and clean all exposed surfaces of the
Injector / Blending Head with detergent
water. Use a small brush to ensure that the
syrup orifices are clear of residual syrup.
4. Place the Injector / Blending Head and the
new replacement o-rings in an approved
sanitizer solution and soak for 1 minute.