Festo SBO***-Q Series, Manual

Page: 58 / 256

3. Installation
3-12
Festo P.BE-SBO-Q-EN en 1602e
Connection Type Designation Description
Connection via
hub or switch SBOA-K30E-M12S Cable Ethernet cable for simple demands
1)
– Straight socket, M12, 4-pin, d-coded
– RJ-45 Ethernet plug
– 3 m long
Direct connection
with the PC SBOA-K30E-M12S Cable
– Coupling Cable coupling for RJ45 plug connector
2)
– Cable Ethernet cross link
2)
1)
The Ethernet cable SBOA-K30E-M12S has been designed for short-term use as a diagnostic cable
or for continuous use as a fixed cable for simple demands.
2)
Only required if the network connection of the PC does not support automatic adaptation of the
send and receive cables (AUTO MDI-X). This accessory is available from dealers.
Tab. 3/5: Cables for the SBO Compact Vision System
For special use in an industrial environment use a screened
flexible Ethernet round cable of category 5 which will fulfil
your requirements as regards resistance to oil, bending
radius, permitted bending cycles etc.
Connections: M12 socket, 4-pin d-coded and RJ45 plug
Cables and plug connectors for special requirements are
available from dealers,
e.g. Franz Binder GmbH & Co. (product series 825) or
from HARTING Electronics GmbH & Co. KG (product series
Harax
®
M12 or Harting RJ Industrial
®
).
Ethernet connection Via the Ethernet interface, the connection can be created to
the PC and displays or higher-level controllers. To permit a
connection, several prerequisites with regard to the devices
network address and the PC must be met (
è
chapter 4.5).
The network characteristics of the device can be adjusted
using the SBO-DeviceManager (
è
chapter 4.5).
For data exchange via EasyIP, Telnet or other protocols, relev­
ant system parameters must be selected (
è
chapter 4.10.7).