Festo SBO***-Q Series, Manual

Page: 118 / 256

4. Commissioning
4-56
Festo P.BE-SBO-Q-EN en 1602e
Output module
Output format for the output module
Recognised
parts types as
binary value Outputs 0 ... 3 of the module are interpreted as
byte value (standard setting). This corresponds to
the recognised parts type (0..15): “0” = parts
type 1.
Recognised
parts types as
1 of N value Outputs 0 ... 3 of the module are interpreted as
individual bits and correspond to the recognised
parts type (0 ... 3): “Bit 0” = parts type 1.
Check program
output The functions of outputs 0 ... 3 of the module are
defined via the check program, “I/O access” tool.
The output format for the output module is defined via sys­
tem parameters.
Further information on the process and signal sequence can
be found in chapter 4.9 ff.
Further information on the modules can be found in the
P.BE-CP-EA-CL manuals.
Use of the PLC run-time system “CoDeSys embedded” also
allows use of an I/O expansion. The following I/O modules
are permissible:
– CP-A04-M12-CL
– CP-E08-M12-CL
– CP-E08-M8-CL
– CP-E16-KL-CL
Make sure that the system parameter “Function at
CANinterface” has been configured to the value
“Off(CoDeSys)”.