Festo SBO***-Q Series, Manual

Page: 128 / 256

4. Commissioning
4-66
Festo P.BE-SBO-Q-EN en 1602e
Commissioning:
1. Switch the system off in order to avoid faults or damage.
Disconnect the power supply to the Compact Vision
System and to the device to be coupled (e.g. CPX-FEC or
FED).
2. Using the specified cables, connect the Compact Vision
System to the device to be connected, e.g. via an Ethernet
switch or hub.
3. Reconnect the power supply.
4. Make a connection to the device with the CheckKon
program and set the system parameter “EasyIP Server”
to “On”.
5. Set the IP address of the Compact Vision System at the
device to be connected.
6. Program the device to be connected to enable it to access
Compact Vision System data.
General information on inputs can be found in chapter 4.10.1.
The available memory addresses and their function can be
found in appendix A.6.
4.10.8 Use of the Ethernet interface with Telnet
The device makes available the Telnet protocol for communic­
ation with a higher-level controller, robot or PC. This permits
very wide-ranging output and control possibilities. Inspection
results can be processed further in the higher-level controller,
in order to grab a part with a robot, for example.
Support for the Telnet function by the Compact Vision System
must be enabled via the system parameters. Reading and
writing take place via a text-based command line with defined
commands, whereby the data to be read/written are defined
through memory addresses.