FEC AFC3000, Hardware Operation Manual

Page: 101 / 294

Chapter 4 Installation and Wiring
PAGE 4-38

BYPASS : BYPASS Mode signal – Slave (Normally Open)
Output “ON” when a unit is in BYPASS mode on a Slave spindle of both a single system and
a multi system. This signal turns “OFF” when the unit is in RUN (ready to operate) mode.

SPINDLE IN BYPASS : BYPASS Spindle Detected signal – Master (Normally Open)
For a Multi System (Master Spindle): Output “ON” when any of the connected spindles is in
BYPASS mode.

SEQUENCE SELECTED BIT 0~4 : Sequence Select Confirmation Bit (Binary coded)

PARAMETER SELECTED BIT 0~4 : Parameter Select Confirmation Bit (Binary coded)
Output confirmation of the SEQUENCE / PARAMETER SELECT 0~4 input selections.
These bits are active according to what sequence/parameter is set from the
sequence/parameter select inputs. Used to confirm proper selection before fastening starts.
For a Multi System (Master Spindle) the output will differ depending on the status of the
BANK SELECT signal:
If BANK SELECT is “OFF” outputs will reflect the Sequence Selected
If BANK SELECT is “ON” outputs will reflect the Parameter Selected
PAR/SEQ
SELECT BIT 4
Pin No.
： ： ： ：
24
PAR/SEQ
SELECT BIT 3
Pin No.
： ： ： ：
23
PAR/SEQ
SELECT BIT 2
Pin No.
： ： ： ：
22
PAR/SEQ
SELECT BIT 1
Pin No.
： ： ： ：
21
PAR/SEQ
SELECT BIT 0
Pin No.
： ： ： ：
20
Parameter
(Sequence)
No.
OFF OFF OFF OFF OFF 1
OFF OFF OFF OFF ON 2
OFF OFF OFF ON OFF 3
OFF OFF OFF ON ON 4
OFF OFF ON OFF OFF 5
OFF OFF ON OFF ON 6
OFF OFF ON ON OFF 7
OFF OFF ON ON ON 8
OFF ON OFF OFF OFF 9
OFF ON OFF OFF ON 10
OFF ON OFF ON OFF 11
OFF ON OFF ON ON 12
OFF ON ON OFF OFF 13
OFF ON ON OFF ON 14
OFF ON ON ON OFF 15
OFF ON ON ON ON 16
ON OFF OFF OFF OFF 17
ON OFF OFF OFF ON 18
ON OFF OFF ON OFF 19
ON OFF OFF ON ON 20
ON OFF ON OFF OFF 21
ON OFF ON OFF ON 22
ON OFF ON ON OFF 23
ON OFF ON ON ON 24
ON ON OFF OFF OFF 25
ON ON OFF OFF ON 26
ON ON OFF ON OFF 27
ON ON OFF ON ON 28
ON ON ON OFF OFF 29
ON ON ON OFF ON 30
ON ON ON ON OFF 31
ON ON ON ON ON 32