MLC 104 IP Plus Series • Operation, Features, and Cabling
10
Display On and Off
Buttons (page
10
)
Input Selection Buttons
Front Panel Features and Operation
Front panel features are shown at right.
Most of the features and LED
indications are described and
shown in the “Rear and Side Panel
Features and Connections” section
paired with the descriptions of the
corresponding ports.
NOTE:
The MLC must
be set up in order to
function. See
based Configuration
and Control
starting on
page 34 and the
Global
Configurator Help
file for
information about Global
Configurator, which you
must use to set up the unit.
Buttons
The
MLC 104 IP Plus Series
controllers have backlit buttons. The functions, events,
and scripts associated with these buttons are available with all models. Pressing the
corresponding button on an Extron SCP 104 keypad causes the functions of that button to
be executed exactly as if you had pressed a front panel button.
By default all buttons illuminate brightly when selected (active), and light dimly when
deselected. The button caps are removable so the button labels can be changed. Each
Display On
/
Off
,
Function
/
Room
, and
Input
button can be set up to perform a
sequence of several functions, which can be combinations of the following options:
•
A driver operation
—execute an RS-232 or IR control command that is part of a
device driver (for a projector, VCR, DVD, audio source, or similar device)
•
A time delay operation
—insert delays between executed commands
•
A button light operation—
change the brightness, color, or flashing of a front panel
button
•
A digital input/output operation
—turn the digital output on or off, toggle it, or
pulse it
•
A user-defined RS-232 operation
—issue a non-driver-associated RS-232 command
(one that you programmed separately) via a specific port (MLS RS-232 or the projector
control port) or an internal command for the MLC, itself
1
Display On/Off buttons
— After they have been configured, press the
On
button
to turn the projector or display device on, and press the
Off
button to power it off. By
default, only one of these two buttons can be selected (active) at once. Through the
Global Configurator (GC) software, other functions can be associated with each of these
buttons.
NOTE:
To avoid conflicts with the front panel lockout PIN feature, Extron recommends
configuring the Display Power buttons so that the MLC sends projector or display
commands upon the button
release
instead of on the button
press
.
CONFIG
DISPLAY
VOLUME
MLC 104 IP PLUS
ON
PC
LAPTOP
OFF
1
2
3
4
Front
Panel
Display On and Off
Buttons (page )
Volume Knob and LEDs
(page )
Config (RS-232 host control)
Port (page )
1
1
2
2
3
3
4
4
Input Selection Buttons
Figure 4.
MLC 104 IP Plus Front Panel
)
Config (RS-232 host control)
Port (page
Summary of Contents for MLC 104 IP Plus Series
Page 6: ......