MLC 104 IP Plus Series • SIS
™
Pr
ogramming and Contr
ol
99
Command/Response Table for SIS Commands (continued)
Command
ASCII (Telnet)
(host to MLC)
URL Encoded (web)
(host to MLC)
Response
(MLC to host)
Additional Description
Set button LEDs to blink fast
24
E
2*
X21@
LX
}
W 2%2A
X21@
LX
|
Lbk*2*
X21@]
Read which button LEDs are set
to blink fast
E
2LX
}
W 2LX
|
X21@]
NOTE:
The command to make a button LED blink fast takes precedence over the command to make it blink slowly. If the LEDs for a button are set to blink both fast and
slowly, the LEDs blink fast.
Reset (zap) commands and erase commands
ATTENTION:
•
Review the reset modes carefully. Using the wrong reset mode may result in unintended loss of flash memory programming, port
reassignment, or a controller reboot.
•
Analysez minutieusement les différents modes de réinitialisation. Appliquer le mauvais mode de réinitialisation peut causer une perte
inattendue de la programmation de la mémoire flash, une reconfiguration des ports ou une réinitialisation du contrôleur.
Erase the flash memory
24
E
ZFFF
}
W ZFFF
|
Zpf
]
Reset all device settings to factory defaults
24
E
ZXXX
}
W ZXXX
|
Zpx
]
The “reset all settings” command does not
affect IP settings or flash memory.
NOTES:
•
The ZXXX command does not reset any IP-related settings such as the IP address, subnet mask, and gateway IP address. It also does not affect user files
stored in flash memory.
•
Receive timeout periods are reset to defaults, port redirection settings are cleared and ended.
Reset all device settings and delete files
24
E
ZY
}
W ZY|
Zpy
]
NOTES:
•
This command is intermediate between the ZXXX and ZQQQ commands. It is an absolute system reset
excluding
IP settings (IP address, subnet mask,
gateway IP address, unit name, DHCP settings, port mapping). This allows you to maintain communication with the MLC. Files, file directories, and passwords
are erased by this command. This reset is recommended after you perform a firmware update.
•
This command is supported by MLCs with firmware of version 1.03 or higher.
Absolute system reset
24
(mode 5 reset)
E
ZQQQ
}
W ZQQQ
|
Zpq
]
Reset all settings/memories. The ZQQQ
command resets everything (all settings,
adjustments, the IP address, and subnet
mask) to the factory default values. Files
in flash memory are also erased by this
command.
The firmware version does not change.
The IP address is reset to 192.168.254.254,
the subnet mask is reset to 255.255.0.0.
NOTE:
This command is identical to
reset mode 5
on page 31 in “Operation,
Features, and Cabling.”
Summary of Contents for MLC 104 IP Plus Series
Page 6: ......