epm
Maintenance, Service
December 2004 Edition
Operating Manual CIG compact TMS Duplex Automatic Soldering Machine
Page 8-33
Hollow wave
(potentiometer
P1
)
Solder must not overrun at 40% stand-by
Full wave
(potentiometer
P2
)
Solder must not overrun at 40% stand-by
Carrier separating
(potentiometer
P4
)
The smallest distance between two carriers should be appr. 150 mm. Turn the potenti-
ometer clockwise to increase the distance.
O
2
-ppm-value
(potentiometer P8)
Setting the ppm-value of the residual oxygen analyzer on the front panel display
(range: x 10). Set the ppm-value so that both values correspond with each other.
The position of the potentiometer on the motherboard is shown in the following figure.
Fig. 8-2. Position of the potentiometers on the motherboard
