Endress+Hauser Proline Promass F 200 HART, Operating Instructions Manual

Page: 60 / 158

Commissioning Proline Promass F 200 HART
60 Hauser
Operating mode Specify the output as a pulse,
frequency or switch output. • Pulse
• Frequency
• Switch
The picklist depends
on the selected device
order (
®
ä 26).
Pulse
Assign pulse output Select the process variable for
the pulse output. • Off
• Mass flow
• Volume flow
• Corrected volume flow Mass flow
Mass unit Select the unit for mass.
Result
The selected unit is taken
from:
Mass flow unit
Unit choose list Country-dependent:
• kg
• lb
Volume unit Select the unit for volume.
Result
The selected unit is taken
from:
Volume flow unit
Unit choose list Country-dependent
• l
• gal (us)
Corrected volume unit Select the unit for standard
volume.
Result
The selected unit is taken
from:
Corrected volume flow unit
Unit choose list Country-dependent:
• Nl
• Scf
Corrected volume flow
calculation Select the reference density
for calculating the corrected
volume flow. • Fixed reference density
• Calculated reference
density
Calculated reference density
Reference density unit Select the unit for reference
density.
Result
The selected unit applies for:
– Outputs
– Low value partial filled
pipe detection
– High value partial filled
pipe detection
– Simulation process
variable
– Fixed reference density
– Density adjustment (in the
Expert menu)
Unit choose list Country-dependent:
• kg/Nl
• lb/scf
Linear expansion coefficient Enter the linear, medium-
specific expansion coefficient
for calculating the reference
density.
0 to 1 [1/K] 0 [1/K]
Square expansion coefficient For media with a non-linear
expansion pattern, use this
function to enter a quadratic,
medium-specific expansion
coefficient for calculating the
reference density.
0 to 1 [1/K
2
] 0 [1/K
2
]