Diagnostics and troubleshooting
Proline Promass F 200 HART
102
Hauser
Navigation path
"Expert" menu
®
System
®
Diagnostic handling
®
Diagnostic behavior
®
Assign behavior of
diagnostic no. xxx
A0014048-EN
å
26
Illustrated using the example of the local display
You can assign the following options to the diagnostic number as the diagnostic behavior:
Options
Description
Alarm
Measurement is interrupted. Signal outputs and totalizers assume the defined alarm condition. A
diagnostic message is generated.
For local display with touch control: the background lighting changes to red.
Warning
Measurement is resumed. The signal outputs and totalizers are not affected. A diagnostic message
is generated.
Logbook entry only
The device continues to measure. The diagnostic message is entered in the Event logbook (events
list) submenu only and is not displayed in alternation with the measured value display.
Off
The diagnostic event is ignored, and no diagnostic message is generated or entered.
12.5
Overview of diagnostic information
Diagnostic
number
Short text
Remedy information
Status
signal
from the
factory
Diagnostic behavior
from the factory
Diagnostics for the sensor
022
Sensor temperature
Temperature circuit failure!
1. Change main electronic module.
2. Change sensor.
F
Alarm
044
Sensor drift
Electrodynamic sensor signal deviation!
1. Check or change main electronics.
2. Change sensor.
S
Warning
*
046
Sensor limit
The measuring tube oscillation
frequency is outside the permitted
range!
1. Inspect sensor.
2. Check process conditions.
S
Warning
*
062
Sensor connection
1. Change main electronic module.
2. Change sensor.
F
Alarm
082
Data storage
1. Change main electronic module.
2. Change sensor.
F
Alarm
083
Memory content
1. Restart device.
2. Restore data.
3. Change sensor.
F
Alarm
*
Diagnostic behavior can be changed: "Adapting the diagnostic behavior" section (
