5/01
4/47
19. Fit bearing thrust washer. Place the original
spacer against the bearing and check that the snap
ring will fit into its groove without free play. Check
at several places around the diameter of the shaft.
If there is free play, or the snap ring will not fit into
the groove, a new thicker or thinner spacer respec-
tively will be required in place of the original.
Graded spacers are available in the following six
thicknesses, marked with part number indicated in
the table,
20. If removed, install a new oil seal into the input
shaft bearing front cover using the special tool.
Press the seal firmly down to the shoulder ensuring
the seal is not damaged.
21. Lubricate the shaft seal surface and apply
Loctite 5900 sealant to the mating face of the front
cover. Install the front cover and tighten the cap-
screws to the correct torque (35 to 39Nm).
22. Select a shim pack and place it against the
layshift bearing cup. Place the spacer on top of the
shim.
Note:
The shim pack must stand proud of the front
face of the case when the bearing cup is fully seat-
ed against the bearing cone and roller assembly.
Shims are available in the following thicknesses.
Part No.
Thickness (mm)
F88891
0,051
F88892
0,127
F88893
0,254
F88894
0,508
Spacer 8875879
2,40
Part No.
Thickness (mm)
8872484
3,70
8872485
3,75
8874486
3,80
8872487
3,85
8872488
3,90
8872489
3,95
When the correct thickness spacer has been
selected and fitted, fit the new snap ring.
Summary of Contents for Roadranger TRSM4106
