![background image](http://html1.mh-extra.com/html/eaton/roadranger-trsm4106/roadranger-trsm4106_service-manual_2353178081.webp)
5/01
4/46
13. Lower the hoist to allow the mainshaft, layshaft
and selector shaft to seat into their respective
bearings or bushes. Remove the special tool.
Ensure the selector block is positioned so it does
not foul the front case.
14. On overdrive transmissions, install the fork
pads into the 5th/6th overdrive selector fork.
Engage the fork and pads into the synchroniser
sleeve.
15. Apply Loctite 5900 sealant to the mating flange
on the rear case and install the front case. Install
the capscrews and nuts.
16. On overdrive transmissions, using a suitable
probe as illustrated, align the pivot pins with the
holes in the case. Apply sealer (Loctite 518) to the
pivot pin flange and install the pins.
17. When aligning the right hand pin, use a screw-
driver and lift the selector through the remote con-
trol aperture. Tighten the capscrews to the correct
torque (20 to 40Nm).
18. Fit the input shaft bearing ensuring oil feed
hole is kept clear.
Summary of Contents for Roadranger TRSM4106
