![background image](http://html1.mh-extra.com/html/eaton/roadranger-trsm4106/roadranger-trsm4106_service-manual_2353178039.webp)
5/01
4/4
7. Ensure neutral is engaged and remove the
remote control housing bolts. Use a soft faced mal-
let to separate the housing from the transmission.
8. Measure the diameter of the core plug as shown.
If the diameter is 32mm then the retaining pin must
be removed as explained below. If the core plug
diameter is 37mm then a retaining pin is not fitted
therefore the following procedure can be missed
9. Remove the rear PTO cover. Using the special
tool or an 8 mm punch, drive the reverse idler shaft
grooved pin INWARDS until the end is approxi-
mately 12 mm below the face of the hole. Do not
allow the pin to ’bottom’ against the shaft bore.
10 Position the transmission forward end upper-
most on the stand or wooden cradle and remove
the detent spring cover plate, spring and plunger
as above or detent assembly (see below).
11.
32mm
37mm
Summary of Contents for Roadranger TRSM4106
