Docomo FOMA P704i, Manual

Page: 478 / 495

41
The operation below explains how to set an access
point name (APN) for packet communication. You can
register up to 10 access point names (APNs), which are
managed with cid1 to cid10.
When using “mopera U” or “mopera”, you do not need
to set the access point name (APN).
The operation below is the example where you use
“XXX.abc” as the access point name (APN) and use the
FOMA USB Cable (option). For the actual access point
name (APN), contact your Internet service provider or
network administrator.
The setting here will be the access point number for
dial-up network setting (see page 41).
For packet communication, you can specify whether to
notify your caller ID (caller ID notified/not notified).
The caller ID is your important information; so, take a
great care to notify your caller ID. You can use AT
commands (
_ DGPIR command) to specify “caller ID
notified/not notified” before dial-up connection.
1
“ [
スタート
(Start)]”
“
接続先
(Access point)”
Click “
接続またはネットワークをセットアッ
プします
(Setup the connection or network)”.
2
Select “ ダイヤルアップ接続をセットアップしま
す (Setup the dial-up connection)”, then click
“ 次へ (Next)”.
3
If the display for selecting a modem appears,
click “FOMA P704i”.
p The display for selecting a modem appears only when you have
registered two or more modems.
Set an Access Point Name (APN)
Set Caller ID Notified/Not Notified
Set Dial-up Network
4
Enter any name in the “ 接続名 (Connection
name)” field.
p Here, “SAMPLE” is entered as an example.
5
Enter an access point number in the “
ダイヤル
アップの電話番号
(Phone number for dial-up)”
field.
p When connecting to “mopera U”, enter “ _ 99 ___ 3#” as the
access point number.
6
Enter the user name and password supplied
from your Internet service provider or network
administrator in the “
ユーザー名
(User name)”
and “
パスワード
(Password)” fields. Then
click “
接続
(Connect)”
Click “
スキップ
(Skip)”.
p When connecting to “mopera U” or “mopera”, you can leave the
user name and password fields blank.
p Only confirm the setting contents without connecting here.
7
Click “ 接続をセットアップします (Setup the
connection)” Click “ 閉じる (Close)”.
8
“ [
スタート
(Start)]” “
接続先
(Access
point)” Highlight the access point which is
finished with connection, and select “
プロパ
ティ
(Property)” after the right click.