Dionex ASE 100, Operator'S Manual

Page: 94 / 150

ASE 100 Operator’s Manual
5-24
Doc. 031842-01 5/02
8. Remove the right side panel of the ASE 100:
a. Using a Phillips screwdriver, remove the two screws on the inner
front panel, near the needle assembly (see Figure 5-5).
b. Insert a screwdriver into the hole located beneath the top screw
hole (see Figure 5-5). Push the screwdriver in until the right side
panel slides back about 1/2 inch. To prevent scratches or other
damage to the panel, do not let the panel fall onto the
workbench.
c. Remove the right side panel from the system and set it aside.
9. Remove the left side panel of the ASE 100:
a. Using a Phillips screwdriver, remove the two screws in the upper
left section of the inner front panel (see Figure 5-10).
b. Gently slide the left side panel backward as far as it can travel
(about 1/2 inch). Pull the panel to the left and remove it from the
system.
Be careful not to damage the mounting tabs on the left side
panel.
Figure 5-10. Removing the Left Side Panel