Dionex ASE 100, Operator'S Manual

Page: 100 / 150

ASE 100 Operator’s Manual
5-30
Doc. 031842-01 5/02
7. Remove the lower trim panel of the ASE 100:
a. Stand directly in front of the ASE 100, with both hands facing
palm upwards.
b. Hook the first two fingers of each hand under the top edges of the
bottle holders, near the
WASTE
and
COLLECTION
labels (see
Figure 5-3).
c. Brace your thumbs against the bottom of the cell door and the
control panel. Pull forward until the top of the trim panel pops off
the ball studs that secure it to the system.
d. Note the small round depressions on the left and right sides of the
trim panel, near the bottom (see Figure 5-4). Place your index
fingers in these depressions and pull forward until the bottom of
the trim panel pops off.
e. Pull the trim panel completely off, exposing the inner front panel,
and set the trim panel aside.
8. Remove the left side panel of the ASE 100:
a. Using a Phillips screwdriver, remove the two screws in the upper
left section of the inner front panel (see Figure 5-10).
b. Gently slide the left side panel backward as far as it can travel
(about 1/2 inch). Pull the panel to the left and remove it from the
system.
Be careful not to damage the mounting tabs on the left side
panel.