Dionex ASE 100, Operator'S Manual

Page: 47 / 150

3 • Operation and Maintenance
Doc. 031842-01 5/02
3-15
3. The
METHOD EDITOR
screen displays the parameters for the method last
selected on the
SETUP
screen (see Section C.1.3). If method 1 is not currently
displayed, press
ENTER
to move the cursor to the method editing field. Use
an arrow button to step through the method numbers (1 through 24). When 1
is displayed, press
ENTER
.
4. All method 1 parameters are set to the default values (see Table 3-3). Follow
the steps below to edit the method as required.
a. Using an arrow button, move the cursor to the first parameter that
you want to change (for example,
TEMPERATURE
).
b. Press ENTER to move the cursor to the editing field for this
parameter. (This also highlights the value currently selected here.)
NOTE If you decide not to edit this field, press
MENU
to return the cursor to the left margin of the
screen.
c. Press an arrow button to step through the values allowed for the
highlighted parameter. (Pressing and holding the arrow button
steps through the values more rapidly.) When the required value
is displayed, press
ENTER
to save it and to return the cursor to
the left margin of the screen.
d. If other changes are required, repeat Steps a-c.
5. When you finish editing, use one of the following options to save the method.
To save to the current method number:
NOTE Saving to the current method number will
permanently overwrite the previous version of the
method. There is no way to undo this action.
a. Using an arrow button, move the cursor to
SAVE
.
b. Press
ENTER
to move the cursor to the
SAVE
editing field.
c. Press ENTER to save the modified version of the method to the
current method number. The screen displays a message
confirming that the method was saved.
d. Press
MENU
to exit the
METHOD EDITOR
screen and return to the
MAIN
screen.