Dionex ASE 100, Operator'S Manual

Page: 104 / 150

ASE 100 Operator’s Manual
5-34
Doc. 031842-01 5/02
17. Reinstall the left side panel:
a. Hold the panel against the left side of the system. Engage the
small tabs on the top and bottom of the panel with the slots in the
chassis. Pull the panel forward until it locks into place.
b. Replace the two Phillips screws on the inner front panel.
18. Carefully align the lower trim panel with the edges of the instrument, and then
gently push the panel into place.
19. Reinstall the waste bottle.
20. Turn on the ASE 100 main power switch.
21. Reconnect the gas source at the ASE 100 rear panel and turn on the gas
supply.
5.11 Replacing the Main Power Fuses
1. Turn off the ASE 100 main power switch and disconnect the main power cord.
2. The fuse holder is part of the main power receptacle on the ASE 100 rear
panel (see Figure 5-18).
Note the recessed lock located on the bottom of the fuse holder. Using a small
screwdriver, push the tab on the recessed lock upward to release the lock.
When the fuse holder pops out slightly, pull the fuse holder straight out of its
compartment.
HIGH VOLTAGE—Disconnect the main power cord from its
source, as well as from the rear panel of the ASE 100.
HAUTE TENSION—Débranchez le cordon d'alimentation
principal de sa source et du panneau arrière du ASE 100.
HOCHSPANNUNG—Ziehen Sie das Netzkabel aus der
Steckdose und der Netzbuchse auf der Rückseite des ASE 100.