Dionex ASE 100, Operator'S Manual

Page: 50 / 150

ASE 100 Operator’s Manual
3-18
Doc. 031842-01 5/02
5. The
METHOD EDITOR
screen displays the parameters for the method last
selected on the
SETUP
screen (see Section C.1.3). If this is not the method you
want to edit, press
ENTER
to move the cursor to the method editing field.
Press an arrow button to step through the method numbers (1 through 24).
When the correct method number is displayed, press
ENTER
to display the
parameters for this method.
6. Begin editing the method as follows:
a. Using an arrow button, move the cursor to the first parameter that
you want to change (for example,
TEMPERATURE
).
b. Press ENTER to move the cursor to the editing field for this
parameter.
c. Press an arrow button to step through the values allowed for the
highlighted parameter. When the required value is displayed,
press
ENTER to save it and to return the cursor to the left margin
of the screen. Figure 3-8 shows how the screen would look after
changing the temperature from the previous setting (100
°
C) to
150
°
C.
7. Repeat Step 6 to change other parameters, if required.
8. When you finish editing, assign a number to the new method as follows:
a. Move the cursor to
SAVE
.
b. Press
ENTER
to move the cursor to the editing field.
c. Press an arrow button to step through the method numbers. When
the desired number is displayed, press
ENTER
to save the new
Figure 3-8. Method Editor Screen after Editing (Additional text shown)