Dionex ASE 100, Operator'S Manual

Page: 86 / 150

ASE 100 Operator’s Manual
5-16
Doc. 031842-01 5/02
6. Remove the right side panel of the ASE 100:
a. Using a Phillips screwdriver, remove the two screws on the inner
front panel, near the needle assembly (see Figure 5-5).
b. Insert a screwdriver into the hole located beneath the top screw
hole (see Figure 5-5). Push the screwdriver in until the right side
panel slides back about 1/2 inch. To prevent scratches or other
damage to the panel, do not let the panel fall onto the
workbench.
c. Remove the right side panel from the system and set it aside.
7. The relief valve is installed in the upper left corner of the component panel
(see Figure 5-7). Disconnect the green gas tubing from the elbow press fitting
on the valve.
8. Disconnect the stainless steel line from the right side of the valve. (This tubing
connects to the pump transducer.)
Figure 5-7. Connections to the Relief Valve