Dionex ASE 100, Operator'S Manual

Page: 99 / 150

5 • Service
Doc. 031842-01 5/02
5-29
20. Reinstall the left side panel:
a. Hold the panel against the left side of the system. Engage the
small tabs on the top and bottom of the panel with the slots in the
chassis. Pull the panel forward until it locks into place.
b. Replace the two Phillips screws on the inner front panel.
21. Reinstall the right side panel:
a. Hold the panel against the right side of the system. Engage the
small tabs on the top and bottom of the panel with the slots in the
chassis. Pull the panel forward until it locks into place.
b. Replace the two Phillips screws on the inner front panel.
22. Carefully align the lower trim panel with the edges of the instrument, and then
gently push the panel into place.
23. Reinstall the waste bottle.
24. Turn on the ASE 100 main power switch.
25. Reconnect the gas source at the ASE 100 rear panel and turn on the gas
supply.
5.10 Replacing the Lower AutoSeal Tip
1. Make sure the ASE 100 power is turned on. (This ensures that the AutoSeal
mechanism is lowered.)
2. Toggle the needle switch to the
UP
position. If a collection bottle is installed,
remove the bottle from the bottle holder and set it aside.
3. Turn off the gas supply. Disconnect the gas source at the ASE 100 rear panel
and let the system vent.
4. Turn off the ASE 100 main power switch.
5. Check that the cell door is closed.
6. Unscrew the waste bottle from the bottle cap and set the bottle aside.