Dionex ASE 100, Operator'S Manual

Page: 119 / 150

B • Installation
Doc. 031842-01 5/02
B-9
3. Insert the solvent outlet line extending from the underside of the cap
assembly (P/N 051977) into the solvent bottle (see Figure B-5). Make
sure the in-line filter rests on the bottom of the bottle. (This prevents
air from being drawn through the line.)
4. Hand-tighten the red lock ring cap securely over the stopper.
5. Screw the fitting on the solvent outlet line into the connector labeled
SOLVENT
.
6. Push the fitting on the gas inlet line into the connector labeled
GAS
.
(To disconnect the line, push the small latch at the top of the
connector toward the center of the connector.)
NOTE Always connect the outlet line to the
SOLVENT
connector first, and then the inlet line to the
GAS
connector. Reverse this order when disconnecting
the lines. It is not necessary to disconnect the solvent
and gas lines before refilling the solvent bottle.
Figure B-5. Solvent Bottle Connections (Top view)