
Delem
V1101, 2.1
2
Machine parameters menu
2.1 Introduction
In this chapter the selection possibilities of the machine parameters menu are explained. The
next selection possibilities are discussed:
•
selection procedure machine parameters menu (section 2.2);
•
a brief introduction on the Y-axis and general parameters (section 2.3);
•
a brief introduction on the auxiliary axes (section 2.4);
•
notes about module configuration and module software (section 2.5);
•
update control procedure (section 2.6);
•
machine parameters backup procedure (section 2.7);
•
changing the menu name (section 2.8);
•
changing the access code (section 2.9);
•
enabling and disabling options (section 2.10).
2.2
Selection procedure of machine parameters menu
The selection procedure of the machine parameters menu is the same for each type of control of the
DA-60 series.
Do the following to get access to the machine parameter menu:
1. Select the programming mode.
2. Enter 19 to select the machine parameter menu.
3. Enter the access code.
The default access code is 14753 for changing a basic set of machine parameters. The machine
parameters followed by (2) can not be changed with this code. When you want to change all the
machine parameters you require the special factory code. This code may only be used by
authorised people.
4. Press the enter key.
In the machine parameter main menu you also find the versions of the current KO-table and the
sequencer file. For detailed information upon the KO-table and Sequencer file version please
contact Delem.
Summary of Contents for DA-65
