Delem DA-65, Manual, Page: 13 / 239

Delem
V1101, 1.2
1.3 Y-axis output signals
Symbol Function
Upper dead point. This output is active when the beam is at the programmed
upper dead point or higher.
ER End of decompression. This output becomes active after the beam has reached
the bending position, the holding time has elapsed and the decompression
distance is completed. It goes low again (inactive) when the opening input (
8
)
becomes active.
Mute output. This output becomes active when the beam reached the muting
point. This output stays active as long as the beam is below the mute position.
CNC-started. This output is active when the start button on the DA-control is
pressed.
Special mute output / 2nd mute (for servo hydraulics). An optional mute output
can be used to obtain that the beam will stop more accurate at the muting point.
This feature can be useful when using servo hydraulics. The optional mute
output will be active from a certain distance before the actual muting point.
Figure 1.3.a
The braking ramp for stopping at the optional muting point is computed automatically by the
control. The distance between the two muting points is fixed in the software. This value can only
be changed by Delem on request. The default value is 0 mm. This means that the two mute
outputs become active at the same time.