Table 3.15
[Source] phase angle analogue output functions
Function
Details
[Source] > Phase angle > [Equipment] | Phase angle L1-L2
[degrees]
The controller outputs the phase angle between L1 and L2.
[Source] > Phase angle > [Equipment] | Phase angle L2-L3
[degrees]
The controller outputs the phase angle between L2 and L3.
[Source] > Phase angle > [Equipment] | Phase angle L3-L1
[degrees]
The controller outputs the phase angle between L3 and L1.
[Source] > Phase angle > [Equipment] | A-B phase angle L1
[degrees]
The controller outputs the phase angle between L1 of the
source and L1 of the busbar.
[Source] > Phase angle > [Equipment] | A-B phase angle L2
[degrees]
The controller outputs the phase angle between L2 of the
source and L2 of the busbar.
[Source] > Phase angle > [Equipment] | A-B phase angle L3
[degrees]
The controller outputs the phase angle between L3 of the
source and L3 of the busbar.
3.3.3 [Busbar] AC measurements
Assign the AC measurement function to an analogue output under
Configure > Input/output
. Select a hardware module with an
analogue output, then select the output to configure.
Function names
The busbar AC measurement function names follow these formats:
[Busbar] > [Physical quantity] > [Equipment] | [Measurement] [[unit]]
. For example,
Busbar A > Apparent power (S) > Busbar A
| Total [kVA]
.
Table 3.16
[Busbar] AC measurement function names for each controller type
Controller type
[Busbar]
[Equipment]
GENSET
Busbar
Busbar
EMERGENCY genset
Busbar
Busbar
SHAFT generator
Busbar
Busbar
SHORE connection
Ship busbar
Busbar
BUS TIE breaker
Busbar B
Busbar B
Table 3.17
[Busbar] voltage analogue output functions
Function
Details
[Busbar] > Voltage (V) > [Equipment] | L1-N [V AC]
The controller outputs the L1-N voltage from the busbar.
[Busbar] > Voltage (V) > [Equipment] | L2-N [V AC]
The controller outputs the L2-N voltage from the busbar.
[Busbar] > Voltage (V) > [Equipment] | L3-N [V AC]
The controller outputs the L3-N voltage from the busbar.
[Busbar] > Voltage (V) > [Equipment] | N [V AC]
The controller outputs the N voltage from the busbar.
[Busbar] > Voltage (V) > [Equipment] | L1-L2 [V AC]
The controller outputs the L1-L2 voltage from the busbar.
[Busbar] > Voltage (V) > [Equipment] | L2-L3 [V AC]
The controller outputs the L2-L3 voltage from the busbar.
[Busbar] > Voltage (V) > [Equipment] | L3-L1 [V AC]
The controller outputs the L3-L1 voltage from the busbar
[Busbar] > Voltage (V) > [Equipment] | Positive sequence [V
AC]
The controller outputs the magnitude of the positive sequence
voltage.
DESIGNER'S HANDBOOK 4189340911K UK
Page 59 of 521
