1. Introduction
1.1 About the Designer's handbook
1.1.1 General purpose
This is the designer's handbook for DEIF’s Protection and Power Management controller, PPM 300. The designer's handbook
provides information required to design a system with PPM 300 controllers, and for configuring the controllers.
DANGER!
Read this manual before designing the system. Failure to do this could result in human injury or damage to the equipment.
1.1.2 Intended users of the Designer's handbook
The Designer's handbook is primarily for the person who designs the control system, electrical system, and communication system
where the controllers are installed. This includes drawing the system drawings, setting the controller parameters, and selecting and
setting up the protections and functions.
The Designer's handbook can also be used during commissioning to check the design drawings and the controller parameters.
Operators may find the Designer's handbook useful for understanding the system and for troubleshooting.
1.1.3 Symbols and conventions in the Designer's handbook
Controller symbols
These symbols show the relevant controller types for a description.
Controller type
Applies to
GENSET
EMERGENCY genset
SHAFT generator
SHORE connection
BUS TIE breaker
Inputs and outputs
Most of the controller inputs and outputs are configurable. You can assign functions to inputs or outputs by using either the display
unit or PICUS. To assign a function, under
Configure > Input/output
, select a hardware module, then select a set of terminals to
configure.
Parameters
You can select and change the parameters by using either the display unit or PICUS, under
Configure > Parameters
.
DESIGNER'S HANDBOOK 4189340911K UK
Page 18 of 521
