Chicago Dryer King Edge VAc, Instruction Manual

Page: 212 / 302

3024-029 King Edge VAC
C-12
Spreader Adjustments (SPR)
The spread delay and spread slow buffer can
be individually adjusted. When SPR is chosen
from the SELECT ADJUSTMENT menu, the
following displays:
SPREAD DELAY .05 SEC
SPREAD SLO BUFFER 45˝
Refer to the table below for information about
each available function to use as a guide in
making adjustments.
Discharge Adjustments (Feed)
The tension time can be individually adjusted.
When FEED is chosen from the SELECT
ADJUSTMENT menu, the following displays:
TENSION .08S VAL 03”/10”
AIR 10”/10” GATE 00”/00”
Refer to the table below for information about
each available function to use as a guide in
making adjustments.
DISCHARGE ADJUSTMENT (FEED)
Adjustment Function Range
(Increment)
Low Range
Select
High Range
Select
Standard
Setting
TENSION
TIME
Determines how long the flatwork
is held in the fully spread position
before the air blasts.
.08 - .20 sec
(.04 sec)
Laydown erratic.
Flatwork not
settled before
laydown.
Unit operation is
slower than peak
performance level.
.12 sec
VAC
Determines the distance the
vacuum is on. Use care when
processing smaller items.
20”-50”
(1”)
Laydown erratic. Improper spacing
between smaller
pieces.
10”
AIR
Determines the distance from
initial discharge air blast to air
assist air blast.
Initiate: 35”-55”
(1”)
Dwell: 40”-90”
(1”)
Initiate: 5”
Dwell: 5”
GATE
Determines the distance from
initial laydown to air brush
up/down and distance over which
brush is down.
Initiate: 40-60”
(1”)
Dwell: 40”-90”
(1”)
Brush comes
down too soon
and causes
flatwork to
bunch.
Ironer has trouble
with proper
transition of piece
from feeder;
Initiate: 46”
Dwell: 40”
SPREAD ADJUSTMENT (SPR)
Adjustment Function Range
(Increment)
Low Range
Select
High Range
Select
Standard
Setting
SPREAD
DELAY
Determines the delay between
the transfer clamps releasing
flatwork and the spreader clamps
beginning to move.
0 - .06 sec
(.01 sec)
Clamps
move before
flatwork is
released from
transfer clamps.
NA
.04 sec
SPREAD SLO
BUFFER
Sets the distance from the
estimated width of the piece at
which the speed of the spreader
clamps begins to slow.
5.0” - 80”
(1”)
Clamps slam at
center position.
Unit operation is
slower than peak
performance level.
50”
TOC INDEX C-TOC