Chicago Dryer King Edge VAc, Instruction Manual

Page: 27 / 302

King Edge Vac Installation
2-9
Electrical Connection
The nameplate (Figure 2-2) , located on the
right rear endframe near the electrical connection
box shows the electrical requirements of the
spreader/feeder. All labor and materials required
to bring the electrical service to the unit are a
local responsibility.
All electrical wiring must comply with local
codes and a qualified electrician must size and
connect the wiring.
CAUTION
The incoming electric
power service must match
the specific electrical
requirements as shown on
the nameplate.
See the unit’s nameplate to determine the
power supply requirements. If high or low voltage
is suspected, check the electrical service to
determine the actual voltage conditions. Improper
or fluctuating voltage may damage motors and
other electrical system components, and void the
factory warranty.
NOTE: A fused disconnect
switch is incorporated into the
electrical connection box. Check
local regulations to determine
whether a separate external fused
disconnect switch is also required.
Follow local codes at all times.
NOTE: The unit is available with
an Interconnected Stop Circuit.
If this circuit is not included, be
sure to follow the Feeder/Ironer
Interlock procedure at the end of
this section.
The unit offers two different types of electrical
connection:
Single Point and Other Cable
Connections (Options)
Standard Wiring
Single Point Electrical Connection
(Option)
Locate the power cable at the right rear of
the unit at the top of the electrical connec-
tion box (Figure 2-16).
Uncoil the cable and connect to the recep-
tacle on the right front of the ironer (Figure
2-17, A). Twist the lock ring to make sure
the connection is secure.
•
•
1.
2.
Figure 2-17: All cable connections are at the right
front of the ironer.
A B C
Figure 2-16: Single point connections simply
installation.
TOC INDEX