Chicago Dryer King Edge VAc, Instruction Manual

Page: 65 / 302

King Edge Vac Preventive Maintenance
4-11
Press a green station Start button at either
operator station.
Looking in from the rear of the machine,
locate the other two primary pressure
gauges of the machine at the left and right
center (Figure 4-16, A, B).
It may be helpful to stand on a short
stool or ladder to see clearly.
Be careful not to come into contact
with the moving discharge ribbons.
The air pressure gauges should be set
as listed below.
A LH Pneumatic Panel 60 psi (415 kPa)
B RH Pneumatic Panel 60 psi (415 kPa)
NOTE: These settings are pre-
set at the factory. Air pressures
can be changed to meet the needs
of different weights of flatwork.
The remaining pressure regulators
only need to be checked and/or
adjusted in the case of a specific
machine performance problem.
Press a red safety STOP button.
6.
7.
•
•
•
9.
Left pneumatic panel pressure gauge.
Right pneumatic panel pressure gauge.
Figure 4-16: Primary air pressure gauges located
inside the body of the machine.
B
A
TOC INDEX