Chicago Dryer King Edge VAc, Instruction Manual

Page: 145 / 302

King Edge Vac Repair
7-11
7.4 Transfer Section
The transfer clamp moves flatwork from
the inlet section to the spread section. While
the transfer section is mechanically simple,
various components require periodic adjustment
or replacement, or occasional repair. These
procedures include:
Transfer Clamp Check and Adjustment
Transfer Clamp Replacement
Transfer Clamp Roller Adjustment
Rodless Air Cylinder Carriage
Adjustment
•
•
•
•
Figure 7-14: The right-hand pneumatic panel is
mounted near the center of the unit.
Transfer Clamp Check and
Adjustment
The transfer clamps must grip the flatwork
firmly and evenly to ensure proper transfer from
the inlet section to the spread section.
Checking the Clamps
Required Tools
7/16” wrench, 1/8” Allen wrench,
small slotted screwdriver
Perform only when the unit is OFF
with power connected.
Use extreme caution.
Turn power ON at the main disconnect
switch.
Turn ON the compressed air supply to
the unit.
Locate the right side pneumatic panel
(Figure 7-14) just to the right of the center
of the machine.
1.
2.
3.
TOC INDEX