Chicago Dryer King Edge VAc, Instruction Manual

Page: 34 / 302

Installation King Edge Vac
2-16
Turn power ON at the main disconnect
switch.
WARNING
Make sure all personal are
clear and that no person
touches any moving part
of the machine. There is no
reason to do so during this
procedure.
Serious injury could result.
Press a green station Start button at either
operator station.
Looking in from the rear of the machine,
locate the other two primary pressure
gauges of the machine at the left and right
center (Figure 2-31, A, B).
It may be helpful to stand on a short
stool or ladder to see clearly.
Be careful not to come into contact
with the moving discharge ribbons.
The air pressure gauges should be set
as listed below.
A LH Pneumatic Panel 60 psi (415 kPa)
B RH Pneumatic Panel 60 psi (415 kPa)
NOTE: These settings are pre-
set at the factory. Air pressures
can be changed to meet the needs
of different weights of flatwork.
The remaining pressure regulators
only need to be checked and/or
adjusted in the case of a specific
machine performance problem.
Press a red safety STOP button.
5.
6.
7.
•
•
•
9.
Left pneumatic panel pressure gauge.
Right pneumatic panel pressure gauge.
Figure 2-31: Air pressure gauges are located inside
the body of the machine.
B
A
TOC INDEX