Chicago Dryer King Edge VAc, Instruction Manual

Page: 75 / 302

King Edge Vac Preventive Maintenance
4-21
From one end of the carrier bracket, re-
move the two screws which secure the
bearings (Figure 4-31, A).
From the other end of the carrier bracket,
remove the top end cap mounting screw
(Figure 4-31, B).
CAUTION
Remove the cap slowly.
There is a compressed
spring just behind the cap
(Figure 4-22). Do not lose this
spring. You will need it for
reassembly.
Slowly pull the cap with the bearing
screws still attached away from the carrier
bracket, being very careful to keep track of
the compressed spring (Figure 4-32).
The bearings will come out as the end cap
is pulled away from the carrier bracket.
Remove the old bearings from the cap
by removing the bearing screws (Figure
4-33).
Mount the new bearings to the cap with
the screws just removed.
Slide the bearings into the carrier brack-
et.
Use a small slotted screwdriver to care-
fully compress the spring under the edge
of the carrier bracket as you slide the end
cap closed (Figure 4-32).
Re-install the end cap mounting screw.
Re-install the bearing screws on the op-
posite end of the carrier bracket.
10.
11.
12.
13.
14.
15.
16.
17.
18.
19.
Figure 4-32: Control the spring when sliding the
end cap into or out of position.
Figure 4-33: Remove the screws which secure the
bearings to the removed end cap.
Figure 4-31: Remove the bearing screws from one
end of the carrier bracket and the end
cap mounting screw from the other.
A
A
B
TOC INDEX