Repair
King Edge Vac
7-24
Pull the belts around until the lacing clips
are accessible.
Remove the connecting pin and attach the
new belt with the pin.
Pull the old belt through until the new belt
is in place. Never turn on the power when
pulling the belts through. This is danger-
ous and unnecessary.
Disconnect the old belt and secure the
replacement belt with a new pin.
Loosen the nut holding the tension on
the spring until the tension on the belts
is correct.
Make sure there is a 1/4” gap between the
tensioning nuts and the fixed retaining
plate (Figure 7-32) to allow proper belt
movement during operation.
3.
4.
5.
6.
7.
8.
Lower Spreader Belt Gap
Adjustment
When the flatwork is pulled to one side as
it is being spread, the gap between the belts
on the pulling side is too small and needs to be
adjusted.
When the spreading and lay down of the
flatwork is not smooth, the gap between the belts
may be too large.
Required Tools
9/16” wrench, pliers, thin slotted
screwdriver
Perform only when the unit is OFF
with power disconnected.
Turn power OFF at the main disconnect
switch.
Turn ON the compressed air supply to
the unit.
Locate the right pneumatic panel (Figure
7-33) just to the right of the center of the
machine.
On the bottom of this unit is the main
solenoid valve. Locate the override screw
on this valve (Figure 7-34).
1.
2.
3.
4.
Figure 7-32: Proper gap between tensioning nut
and fixed plate.
Figure 7-34 Override screw for air solenoid valve
located under pneumatic panel.
Figure 7-33: The pneumatic panel is mounted near
the center of the unit.
TOC
INDEX
Summary of Contents for King Edge VAc
