Canon iR5570 Series, Service Manual

Page: 396 / 684

Chapter 9
9-42
F-9-127
3) Detach the fixing inlet sensor [1] from the fixing inlet guide base.
F-9-128
Be sure to mount the fixing inlet guide base where it was in step 1).
9.5.16.2 Adjusting the Fixing Inlet Guide
0009-4884
- Adjust the position of the solenoid using the two screws [1] so that the
fixing inlet guide will be positioned as indicated when the solenoid
turns on.
F-9-129
<Points to Note When Making Adjustments in th Field>
- The inlet guide is in low position when the solenoid (SL1) goes on.
- The height of the inlet guide must be such that the difference between
the front and the rear must be 0.2 mm or less.
- As necessary, adjust the height of the inlet guide by loosening the
fixing screw on the height adjusting support plate.
9.5.17 Fixing web sensor
9.5.17.1 Removing the Fixing Web Sensor
0009-2913
1) Slide out the fixing feeding unit.
2) Remove the fixing front cover.
3) Remove the fixing drive assembly.
4) Disconnect the connector [1], and detach the fixing web sensor [2].
F-9-130
9.5.18 Fixing shutter sensor
9.5.18.1 Removing the Shutter Sensor
0009-2915
1) Remove the fixing upper unit.
2) Remove the screw [1], and detach the shutter sensor support plate [2].
F-9-131
3) Remove the shutter sensor [1] from the shutter sensor support plate.
F-9-132
9.5.19 Fixing shutter motor
9.5.19.1 Removing the Shutter Motor
0009-2914
[1] [1]
[2] [2]
[3] [3] [4] [5]
[1]
1.6mm
Fixing roller
Pressure roller
Solenoid
Inlet guide
11.1mm 12.7mm
[1]
[1] [2]
[1]
[2]
[1]