Canon imageRUNNER ADVANCE C3500 III Series, Service Manual, Page: 996 / 1252

No. Function Setting range Default value
009 Comparing the number of digits between the sender's telephone number
and the receiver's telephone number 0 to 20 digits 0
010 Line connection identification time 0 to 9999 (x 10 ms) 5500
011 T.30 T1 timer (for reception) 0 to 9999 (x 10 ms) 3500
013 T.30 EOL timer 500 to 3000 (x 10 ms) 1300
015 Hooking detection time 0 to 999 120
016 Time until a temporary response is obtained when switching FAX/TEL 0 to 9 4
017 Pseudo RBT signal pattern ON time 0 to 999 100
018 Pseudo RBT signal pattern OFF time (short) 0 to 999 0
019 Pseudo RBT signal pattern OFF time (long) 0 to 999 200
020 Pseudo CI signal pattern ON time 0 to 999 100
021 Pseudo CI signal pattern OFF time (short) 0 to 999 0
022 Pseudo CI signal pattern OFF time (long) 0 to 999 200
023 CNG detection level when switching FAX/TEL 0 to 7 4
024 Pseudo RBT transmission level when switching FAX/TEL 10 to 20 (TYPE =
STANDARD) 20
025 CNG monitoring time when the answering phone connection function is
set
026 Silent detection level when the answering phone connection function is
set
027 V.21 low-speed flag preamble detection time 20 (-10 ms) 0
028 Off-hook PCB duty settings 1 to 99% 0 (50%)
080 Transmission number restriction: Outside line transmission number *1 0 to 9999 0
*1 : Supported on the platform version 307 or later
002: RTN transmission condition (1)/003: RTN transmission condition (2)/004: RTN transmission
condition (3)
Set the RTN signal transmission condition.
In the case of frequent errors caused by RTN signal transmission at the time of reception, increase the parameters to loosen the
RTN signal transmission condition.
NOTE:
Error codes caused by RTN signal transmission at the time of reception
##104, ##107, ##114, ##201
RTN signal transmission condition (1) is the ratio of error lines for the total number of lines per page of the received image.
RTN signal transmission condition (2) is the reference value (*2) of burst error (*1).
RTN signal transmission condition (3) is the number of errors that fail to meet the reference value of burst error.
*1: Burst error (transmission errors with several continued lines)
*2: Reference value (When "15" is set, transmission error with 15 consecutive lines is recognized as a burst error.)
When any of the above conditions is detected during reception of image signals, RTN signal is sent after reception of the procedure
signal from the sending machine. Increasing such parameter sends less RTN signal.
005: NCC pause time (before ID code)
Set the pause time to be automatically entered between the access code and ID code when dialing on NCC (New Common
Carrier) line.
006: NCC pause time (after ID code)
Set the pause time to be automatically entered between the ID code and the other party's telephone number when dialing on
NCC (New Common Carrier) line.
007: Prepose time at the time of making a call
When automatically making a call, set the time from closing a line to making a call.
009: Comparing the number of digits between the sender's telephone number and the receiver's
telephone number
Set the TSI comparing the number of digits (last XX digits) when matching telephone numbers.
8. Service Mode
974