Canon imageRUNNER ADVANCE C3500 III Series, Service Manual, Page: 780 / 1252

COPIER (Service mode for printer) > OPTION (Specification setting mode) > FNC-SW
VER-CHNG 2 Setting of firmware update operation
Detail To set how to update firmware of PCB/option which has been installed/replaced by comparing the
version of it with the version stored in the Flash PCB of the Main Controller.
If combination of firmware versions of PCB/option stored in the Main Controller and the version in
PCB/option after installation/replacement is not appropriate (operation with the combination of
firmware versions has not yet been checked), failure where analysis is difficult may occur.
It is possible to check the firmware versions at the start of the machine, and automatically write
the firmware stored in the Main Controller in PCB/option collectively as needed.
When 0 is set, versions are not checked and firmware update is not performed. Therefore, it is
necessary to manually update the versions using a USB memory/SST.
When 1 is set, firmware is updated if the version in PCB/option is old. However, it is not updated
if the version is new or old and new versions are mixed.
When 2 is set, a compatible firmware (the version where operation has been checked) is written
from the Main Controller regardless of whether the version in PCB/option is old or new.
Use Case When installing/replacing PCB/option having firmware
Adj/Set/Operate Method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/Adj/Set Range 0 to 2
0: Keep the current firmware version.
1: Update the firmware if the version in PCB/option is older than that stored in the Main controller.
If the version is new or old and new versions are mixed, firmware is not updated.
2: Update the firmware regardless of whether the version is old or new if the version in PCB/option
differs from that stored in the Main Controller.
Default Value 1
Supplement/Memo When updating the firmware, the main menu is displayed on the Control Panel at startup and then
a message prompting to update firmware is displayed.
By pressing [Update], the machine reboots immediately and firmware is updated.
By pressing [Skip], it returns to the main menu. The message is displayed again at next startup.
FAX-STR 1 [For customization]
CE-SW 1 [Reserve]
LIMFNC-M 2 [For customization]
INTR-TML 2 Set ini rtn time: extra-long size ppr fd
Detail To set the offset of initial rotation time when feeding extra-long size paper.
When the result is a negative value, the time becomes "0 second".
Increase the value when a fixing failure occurs on the edge, and decrease the value when
prioritizing productivity.
Use Case - When a fixing failure occurs on the edge while feeding extra-long size paper
- When reducing downtime
Adj/Set/Operate Method Enter the setting value (switch negative/positive by -/+ key) and press OK key.
Caution As the value is larger, FCOT becomes longer.
If the value is too small, a fixing failure may occur on the edge.
Display/Adj/Set Range -2 to 2
-2: -15 seconds, -1: -10 seconds, 0: 0 second, 1: +5 seconds, 2: +10 seconds
Unit sec
Default Value 0
Amount of Change per
Unit
5
8. Service Mode
758