Canon imageRUNNER ADVANCE C3500 III Series, Service Manual, Page: 1187 / 1252

16.
Turn ON the main power switch.
CAUTION:
If the machine does not recognize this equipment,
unplug and then plug the power plug after turning OFF
the main power switch, or turn OFF the main power
switch and then turn it ON within 20 seconds. To avoid
this symptom, unplug the power plug or turn the
breaker OFF when installing.
NOTE:
When a message prompting to turn OFF and then ON the
main power appears, turn OFF and then ON the main
power switch.
17.
If a message prompting the user to update the version
appears, press [Update] to automatically update the
version of this equipment.
NOTE:
If [Skip] is selected, a message prompting the user
toupdate the version will appear every time the host
machine is started.
In the service mode ( Lv.2) shown below, it is possible to
set not to display the message.
COPIER > OPTION > FNC-SW > VER-CHNG
Operation Check
■ Type Settings
Select the country/region of the FAX Board in Service Mode:
FAX > Type > TYPE
This setting performs the parameter settings to match the
communication specification of the country/region.
1.
From the following service mode, Set the TYPE of
country/region to install this machine, and then press
OK.
FAX > Type > TYPE
2.
Confirm that service mode (level 1) parameter below is
"0". In the case, parameter is "1", change to "0".
COPIER > OPTION > DSPLY-SW > SDTM-DSP
NOTE:
Change the parameter to "0" to hide [Settings/
Registration] > [Preferences] > [Timer/Energy Settings] >
[Auto Shutdown Time] and disable the auto shut down.
3.
Turn OFF/ON the main power switch to enable this
setting.
■ Basic Settings
NOTE:
When "System Manager Information Settings" is set, be
sure to follow the direction of user administrator in order
to log in as an administrator.
In this section, make only minimum settings required for FAX
communication.
1. Set the user telephone number.
[Settings/Registration] > [Function Settings] > [Send] >
[Fax Settings] > [Set Line] > [Line 2] > [Register Unit
Telephone Number] > Enter FAX number > [OK]
2. Set the type of telephone line.
[Settings/Registration] > [Function Settings] > [Send] >
[Fax Settings] > [Set Line] > [Line 2] > [Select Line Type]
> Select the line type to connect > [OK]
3. Turn OFF/ON the main power switch after setting the
user telephone numbers and the type of telephone
line.
■ FAX Communication Test
Perform communication test to check if FAX function works
correctly.
1. Switch the control panel display to [Fax] display.
2. Select the sending line.
Press [Fax] > [Options] > [Select Line], select the added
line, then press [OK] button.
3. Send and receive a test original between the
equipment and a remote unit with which a
communication test can be performed and check if
it can be sent and receive correctly.
1. Press [Status Monitor/Cancel] > [Send] > [Job Log]
and select [Fax] from pull down menu.
2. Press [Fax Activity Report] > [OutPut Normally] >
[Start Printing].
9. Installation
1165