Canon imageRUNNER ADVANCE C3500 III Series, Service Manual, Page: 915 / 1252

■ P-STOP
COPIER (Service mode for printer) > TEST (Print test mode) > P-STOP
PRINTER 1 Forcible stop of paper feed
Detail To forcibly stop paper for the next job at the specified position (only once).
Leading edge of paper stops at the specified position so that the cause of a problem can be
identified.
Set 99 when checking an image on the ITB.
When the operation is stopped forcibly, jam code "AAxx" is displayed.
When a normal jam occurs at a position other than the specified position or paper is delivered
without being forcibly stopped, this setting is automatically cleared.
Use Case - When bent paper/skew/wrinkles occur
- When jam occurs frequently
- When checking an image on the ITB
Adj/Set/Operate Method 1) Enter the setting value, and then press OK key.
2) Execute a job (copy/test print).
Paper stops at the specified position.
Caution - Remove the paper being stopped with the normal jam removal procedure. After jam removal, the
job is automatically recovered.
- Display of standard jam code indicates that a jam occurs somewhere other than the specified
position.
- The setting is disabled for job where paper does not pass through the specified position.
- Unfixed toner may be adhered on paper depending on the stop position. Thus, handle it with
care.
Display/Adj/Set Range 0 to 255
0: OFF
20: Before registration (1st side)
21: Before registration (2nd side) *1
30: Before fixing (1st side)
31: Before fixing (2nd side) *1
32: After fixing (1st side)
33: After fixing (2nd side) *1
40: Second delivery (1st side) *2
41: Second delivery (2nd side) *1, *2
70: Reverse position 1 *1, *4
71: Reverse position 2 *1, *3
72: Duplex standby position *1
99: Before fixing (1st side, when checking image)
Any value other than those mentioned above: Not used
*1: Paper is stopped when a duplex job is executed. (Paper is stopped after being reversed.)
*2: Paper may not be stopped depending on the delivery outlet settings. (The 3 Way Unit-D1 must
be installed.)
*3: The size of paper should be the one that passes through the short path (e.g.: A4, LTR, etc.).
*4: The size of paper should be the one that passes through the long path. (e.g.: A4R, LTRR, etc.,
The 3 Way Unit-D1 must be installed.)
Default Value 0
COUNTER (Counter mode)
■ TOTAL
COPIER (Service mode for printer) > COUNTER (Counter mode) > TOTAL
SERVICE1 1 Service-purposed total counter 1
Detail To count up when the printout is delivered outside the machine.
Large size: 1, Small size: 1
A blank sheet is not counted.
Adj/Set/Operate Method N/A (Display only)
Display/Adj/Set Range 0 to 99999999
8. Service Mode
893