Canon imageRUNNER ADVANCE C3500 III Series, Service Manual, Page: 842 / 1252

COPIER (Service mode for printer) > OPTION (Specification setting mode) > IMG-FIX
TMP-TB28 1 Set fixing control temp: coated paper 4
Detail To set the offset of fixing control temperature for coated paper 4 (221 to 256 g/m2).
As the value is changed by 1, the control temperature is changed by 5 deg C.
Increase the value when a fixing failure occurs, and decrease the value when fixing offset occurs.
Use Case When a fixing failure/fixing offset occurs on coated paper 4
Adj/Set/Operate Method Enter the setting value (switch negative/positive by -/+ key) and press OK key.
Caution If the value is too large, fixing offset may occur.
If the value is too small, a fixing failure may occur.
Display/Adj/Set Range -2 to 2
-2: -10 deg C, -1: -5 deg C, 0: 0 deg C, 1: +5 deg C, 2: +10 deg C
Unit deg C
Default Value 0
Amount of Change per
Unit
5
TMP-TB29 1 Set fixing control temp: coated paper 5
Detail To set the offset of fixing control temperature for coated paper 5 (257 to 300 g/m2).
As the value is changed by 1, the control temperature is changed by 5 deg C.
Increase the value when a fixing failure occurs, and decrease the value when fixing offset occurs.
Use Case When a fixing failure/fixing offset occurs on coated paper 5
Adj/Set/Operate Method Enter the setting value (switch negative/positive by -/+ key) and press OK key.
Caution If the value is too large, fixing offset may occur.
If the value is too small, a fixing failure may occur.
Display/Adj/Set Range -2 to 2
-2: -10 deg C, -1: -5 deg C, 0: 0 deg C, 1: +5 deg C, 2: +10 deg C
Unit deg C
Default Value 0
Amount of Change per
Unit
5
EXTH-LP 2 Set fix arch control: heavy ppr/coat ppr
Detail To set the arch amount between secondary transfer and fixing when feeding heavy paper 7 and
coated paper 4/5.
Increase the value when shock image occurs at the trailing edge of heavy paper or coated paper.
The arch amount is decreased so that shock can be alleviated.
Use Case
When shock image occurs at the area around 60 mm or 130 mm from the trailing edge of heavy
paper or coated paper
Adj/Set/Operate Method Enter the setting value, and then press OK key.
Caution Change the value by 1 at a time while checking the symptom. If the value is increased too much
at a time, image at the trailing edge may disturb.
Display/Adj/Set Range 0 to 4
0: Maximum, 1: Large, 2: Medium, 3: Small, 4: Minimum
Default Value 0
Amount of Change per
Unit
15mm
8. Service Mode
820