Canon imageRUNNER ADVANCE C3500 III Series, Service Manual, Page: 852 / 1252

COPIER (Service mode for printer) > OPTION (Specification setting mode) > USER
IDPRN-SW 1 Charge target job set of dept mngm cntr
Detail *Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set the job type that advances the department management counter.
Use Case Upon user's request
Adj/Set/Operate Method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/Adj/Set Range 0 to 1
0:
PRINT category: Inbox Print, Report Print, PDL Print
COPY category: COPY
1:
PRINT category: Report Print, PDL Print
COPY category: COPY, Inbox Print
Default Value 0
CPRT-DSP 1 [For customization]
PCL-COPY 2 Set of PCL COPIES command control method
Detail To set the binder control method of COPIES command with PCL.
Select whether to use the control method of Canon-made PCL or use the same control method of
non-Canon-made PCL.
Use Case Upon user's request
Adj/Set/Operate Method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/Adj/Set Range 0 to 65535
0: Control method of Canon-made PCL (following the value of COPIES command that is specified
for each page to control on a page basis)
1: Control method of non-Canon-made PCL (handling the value of COPIES command, which is
specified for page 1 at the time of Collate mode, as bind figure while the value of COPIES command
for the next page or later is invalid. Same control applies as Canon-made PCL at the time of non-
sorted mode)
2 to 65535: For future use
Default Value 0
CNT-SW 1 Set default dspl items on charge counter
Detail To set default display items of the charge counter on the Counter Check screen.
For details of each type, refer to the Service Manual.
Use Case Upon user's request
Adj/Set/Operate Method
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/Adj/Set Range
0 to 1
0: Type1, 1: Type2
Default Value
0
BCNT-AST 1 Set of box print charge target job
Detail *Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set the job type that advances the count in box print with NE Controller (ASSIST).
Use Case When switching the job type that is subject to counting of the box print with NE Controller
Adj/Set/Operate Method 1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Display/Adj/Set Range 0 to 1
0: PDL job, 1: Copy job
Default Value 0
8. Service Mode
830