Canon imageRUNNER ADVANCE C3500 III Series, Service Manual, Page: 967 / 1252

SORTER (Service mode for delivery options) > ADJUST (Adjustment mode)
PULL-SPD 1 Adj pull-out spd of the ppr end:Sort-A1
Detail To adjust the speed to pull out the trailing edge of paper from the host machine to the built-in shift
sorter.
As the value is changed by 1, the speed is changed by 20 mm/sec.
+: Accelerate
-: Decelerate
Use Case When curl occurs with a long length paper at delivery and the delivered paper interferes with papers
on the tray
Adj/Set/Operate Method Enter the setting value, and then press OK key.
Caution As the value is decreased, productivity may be decreased.
Display/Adj/Set Range -11 to 0
Unit mm/s
Default Value 0
Amount of Change per
Unit
20
SFT-AMT 1 Adj of ppr stack shift amount:Sort-A1
Detail To adjust the offset of shift amount when performing shifting between paper stacks.
As the value is incremented by 1, the shift amount is increased 5 mm to the front/rear.
+: Shift amount is increased
-: Shift amount is decreased
Use Case When the shift amount of paper stack is not appropriate
Adj/Set/Operate Method Enter the setting value (switch negative/positive by -/+ key) and press OK key.
Caution Since the maximum shift amount has been set as the initial setting, the amount is not changed by
entering 1.
Display/Adj/Set Range -1 to 1
-1: Shift amount is 5 mm decreased, 0: Initial setting, 1: Not used
Unit mm
Default Value 0
Amount of Change per
Unit
5
RBLT-PS3 1 Adj of Return Belt height 3:Fin-AA1
Detail To adjust the height of the Return Belt when stacking the 1 sheet on the processing tray.
As the value is changed by 1, the height of the return belt changes by angle of 0.1 degree.
+: Downward
-: Upward
When replacing the Finisher Controller PCB/clearing the RAM data of the Finisher Controller PCB,
enter the value of service label.
Use Case
When the paper alignment position is displaced.
When replacing the Finisher Controller PCB/clearing the RAM data of the Finisher Controller PCB.
Adj/Set/Operate Method Enter the setting value (switch negative/positive by -/+ key) and press OK key.
Caution The height of Return Belt of the stacking 65 sheets adjust in the RBLT-PRS. The height of Return
Belt at the stacking 2 to 64 sheets alignment on the processing tray is the total of setting values
of RBLT-PRS and RBLT-PS3. So adjust again the setting value of RBLT-PS2 if necessary when
changing the setting value of RBLT-PS3.
After the setting value is changed, write the changed value in the service label.
Display/Adj/Set Range -50 to 100
Unit °
Default Value 0
Related Service Mode SORTER> ADJUST> RBLT-PRS,RBLT-PS2
Amount of Change per
Unit
0.1
8. Service Mode
945