Canon imageRUNNER ADVANCE C3500 III Series, Service Manual, Page: 966 / 1252

SORTER (Service mode for delivery options) > ADJUST (Adjustment mode)
SFT-SPD 1 Adj of delivery speed: Fin-AA1/Sort-A1
Detail Fin-AA1
To adjust the delivery speed to the stack tray at collate mode.
As the value is changed by 1, the delivery speed changes by 10 mm/sec.
Sort-A1
To adjust the delivery speed to the stack tray.
As the value is changed by 1, the delivery speed changes by 20 mm/sec.
Use Case When the paper stacking of stack tray is misalignment
Adj/Set/Operate Method Enter the setting value (switch negative/positive by -/+ key) and press OK key.
Caution As the value is decreased, productivity is decreased.
Display/Adj/Set Range Fin-AA1: -5 to 5
Sort-A1: -7 to 5
Unit mm/s
Default Value 0
Amount of Change per
Unit
10/20
STP-SPD 1 Adj dvry speed at staple mode:Fin-AA1
Detail To adjust the delivery speed to the Stack Tray in staple mode or at staple-free stapling.
As the value is incremented by 1, the delivery speed is increased by 10 mm/sec.
Use Case When the paper stacking at staple mode or staple-free binding mode is misalignment
Adj/Set/Operate Method Enter the setting value (switch negative/positive by -/+ key) and press OK key.
Caution - As the value is decreased, productivity is decreased.
- When the buffer operation (simultaneous stack delivery operation) is performed, the delivery
speed does not change. Make the setting whether to perform buffer operation with BUFF-SW.
Display/Adj/Set Range -5 to 5
Unit mm/s
Default Value 0
Related Service Mode SORTER> OPTION> BUFF-SW
Amount of Change per
Unit
10
RBLT-PS2 1 Adj of Return Belt height 2:Fin-AA1
Detail To adjust the height of the Return Belt when aligning papers on the Process Tray.
As the value is changed by 1, the height of the Return Belt is changed by 0.1 mm.
+: Move down
-: Move up
When replacing the Finisher Controller PCB/clearing RAM data, enter the value of service label.
Use Case - When an alignment failure of paper stack occurs in alignment operation at the Process Tray
- When replacing the Finisher Controller PCB/clearing RAM data
Adj/Set/Operate Method Enter the setting value (switch negative/positive by -/+ key) and press OK key.
Caution The height of Return Belt during the paper alignment on the processing tray is the total of setting
values of RBLT-PRS2 and PBLT-PS3, so adjust again the setting value of RBLT-PS2 if necessary
when changing the setting value of RBLT-PRS3.
After the setting value is changed, write the changed value in the service label.
Display/Adj/Set Range -30 to 30
Unit °
Default Value 0
Related Service Mode SORTER> ADJUST> RBLT-PRS/PS3
Supplement/Memo Perform this adjustment after executing adjustment of RBLT-PRS.
Amount of Change per
Unit
0.1
8. Service Mode
944