Canon imagePROGRAF iPF9400S, User Manual

Page: 807 / 972

Important
•
This function is not available with CAD Tracing Paper , CAD Translucent Matte Film , or CAD Clear Film .
•
If adjustment is not possible as expected using special media, try another type of paper, or try Manual adjustment.
(See "Manual Adjustment to Straighten Lines and Colors.")
→P.808
Note
•
Because the results of adjustment vary depending on the type of paper used for adjustment, use the same type of paper as
you will use for printing.
•
If Standard does not improve printing, try adjusting the printhead manually.
(See "Manual Adjustment to Straighten Lines and Colors.")
→P.808
•
If the printhead position was not adjusted during initial setup or when the printhead was replaced, execute Initial adjustmt .
(See "Adjustment When Installing the Printhead.")
→P.810
•
Advanced adjustment can enable superior printing quality when printing fine lines or text at high precision on glossy or semi-
glossy photo or proofing paper.
(See "Enhancing Printing Quality.")
→P.804
Items to Prepare
When Using Rolls An unused roll at least 254.0 mm (10.00 in) wide
When Using Sheets Standard : Six sheets of unused paper, A4/Letter size (or one sheet when using A2)
Simple : One sheet of unused paper, A4/Letter size
Perform adjustment as follows.
1
Load paper.
•
Attaching the Roll Holder to Rolls
→P.538
•
Loading Rolls in the Printer
→P.541
• Loading Sheets in the Printer
→P.563
Important
•
Always make sure the loaded paper matches the type of paper specified on the printer. Adjustment cannot be com-
pleted correctly unless the loaded paper matches the settings.
2
On the Tab Selection screen of the Control Panel, press
◀
or
▶
to se-
lect the Settings/Adj. tab ( ).
Note
•
If the Tab Selection screen is not displayed, press the Menu button.
3
Press the OK button.
The Set./Adj. Menu is displayed.
iPF9400S Automatic Adjustment to Straighten Lines and Colors
User's Guide
Adjustments for Better Print Quality
Adjusting the Printhead
807