9214
– 7 –
4511-7741-02
17. Loosen the screw shown, move it to the
front, and then tighten it again. (1 screw)
NOTE
This step must be performed properly to
prevent any trouble.
Do not move the screw by using the Adjust
Plate. Be sure to move the screw itself.
4510U020AD
Adjust plate
18. Mount the Saddle Unit on the Finisher.
NOTE
Check that the tab of the Saddle Unit is
below the tab of the Shutter.
4511U032AA
19. Using Screws C, secure the Saddle Unit to
the Mounting Bracket (Left). (2 screws)
*
Temporarily tighten the left screw, securely
tighten the right screw, and then securely
tighten the left screw.
4511U033AB
Right
Left
20. Open the Saddle Unit.
21. Using Screw C, secure the Saddle Unit to the
Mounting Bracket (Right). (1 screw)
4511U036AA
22. Place the Mounting Bracket Cover over the
Mounting Bracket.
23. Secure the Saddle to the Mounting Bracket
(Right) using Screw C.
*
Tighten the Saddle together with the Mount-
ing Bracket Cover. (1 screw)
4511U035AB
24. Remove the connector cover from the
Finisher. (1 screw)
25. Remove the knockout.
4511U037AA
26. Remove the existing grounding screw and
secure two ground cables together.
27. Connect the connector.
28. Insert the snap band.
29. Install the connector cover. (1 screw)
4511U038AB
30. Install the Exit Tray.
4511U034AA
4511‑7741‑02.fm 7 ページ 2003年10月3日 金曜日 午前10時11分
Summary of Contents for im2020
