Canon im2020, Setup Instructions

Page: 132 / 143

ZC3500050
– 5 –
4030-7775-02
■
Installing the Power Supply Unit
■
Wiring the Power Harness
1. Remove two handles and the cover from the
rear of the copier (six screws).
4599U010AA
2. Open the edge cover located on the top
surface of the power plug mounting bracket.
3. Remove the connector of the power hookup
harness and close the edge cover.
4599U011AB
4. Install the Power Supply Unit and Metal
Bracket furnished with the Hard Disk Drive to
the left side of the power plug (four screws).
4599U012AA
5. Connect the power hookup harness
connector to the Power Supply Unit.
4599U013AB
1. Connect the Harness that comes with the
Hard Disk Drive to the Power Supply Unit.
4599U018AA
2. Tidy up the Harness into the eight wiring
saddles and two edge covers available on
the copier side.
NOTE
Route the Harness so that the red cable tie
of the Harness is on the upper side of the
wiring saddle.
4599U019AB
Cable Tie
3. Connect the Harness to CN5 of the Network
Interface Card.
4599U034AA