Canon im2020, Setup Instructions

Page: 91 / 143

9214
– 4 –
4511-7741-02
5. Carefully insert the Creasing Unit into the copier along the groove provided in the rear
of the copier.
NOTE
Use care not to allow the parts shown in the illustration to hit against the mating
portions while the Creasing Unit is being inserted.
Insert it with the Guide Plate at the finisher side facing downward shown “OK” in the
illustration.
4511U040AA
Creasing Unit Guide Plate
NG
OK
4511U019AA
Parts
Groove in the rear
6. Place the Creasing Unit Adjusting Plate
beneath the Creasing Unit and temporarily
secure the unit by tightening Screw A (1
screw) only temporarily.
4511U020AB
7. Secure the rear end of the Creasing Unit
using Shoulder Screw A (1 screw).
NOTE
No clearance is allowed between the
Shoulder Screw and the metal bracket.
4511U021AA
8. Secure the Creasing Unit Adjusting Plate
and Creasing Unit using Screw A (1 screw).
9. Securely tighten Screw A which has been
tightened only temporarily in step 6 (1
screw).
4511U022AB
10. Reinstall the Finisher cover and
reinforcement plate. Mount the Finisher to
the copier.
NOTE
For the Finisher mounting procedures, see
Setup Instructions for 9211.
11. Remove the cover (2 screws).
4512U010AB
12. Connect the harness.
4511U023AA
4511‑7741‑02.fm 4 ページ ２００３年１０月３日 金曜日 午前１０時１１分